Check out the new Night Saber WRAITH 500mw laser & new NS68/48 HPR +RED (Brightest red lamp available)

30mm Torch/IR tube Fully adjustable IR/Torch ball mount fits 25mm-40mm scope tubes (Quick detach)

  • Sale
  • £21.99


 30mm Torch/IR Tube

Wind/Elevation adjustable mount 25mm-40mm

Fully adjustable to allow precise alignment of the torch/IR beam.

Rotating ball &  thumb-wheel design  allows easy in the field adjustment & easy removal of the upper section to aid storage.

very sturdy clamping system compared to other adjustable solutions currently available

The lower section stays on the optic & is available in 25mm/30mm - 40mm (25/30mm is supplied with a bush to suit both sizes)

Available in 25/30mm 34mm 36mm & 40mm to allow you to fit most available scope sizes.


The lower section also fits out new NV screen system.

 

Please select options above 

Upper

 

30mm Torch body only

center to center between ring

 Low 50mm

Med 60mm

High 65mm

Lower

25/30mm

34mm

36mm

40mm

The upper & lower parts are available individually if you need to use on multiple optics HERE

Instructions 

Please read carefully prior to fitment.....

Clip the  bushing over your IR/Torch & fit into the adjustable mounting upper part.(the split in the bush should be on the side of  the m4 cap head screw or damage may incur)

Tighten the m4 cap head fully being careful not to over tighten, you can then control the tension  via the thumb wheel allowing you to rotate as desired.

When tightening the 4x cap heads to secure to your scope tube be sure to tighten evenly & be careful not to cross thread the fixings,Only a SMALL amount of resistance on the small side of a allen key is required to ensure these are rock solid and will not budge on your scope tube.They will not feel like a aluminium part when tightened & treating them as so will damage the plastic.

A wrap of electrical tape can be added to your scope tube if required.

Surface finish may vary depending on ABS/PETG type used .

 

Please note these are made in house so 1-5 working days depending on workload/printing schedule .


 

 

 

 

 

 

 

Customer Reviews

Based on 2 reviews Write a review