Windage/Elevation adjustable mount 25mm-40mm
Fully adjustable to allow precise alignment of the torch/IR beam.
Rotating ball & thumb-wheel design allows easy in the field adjustment & easy removal of the upper section to aid storage.
very sturdy clamping system compared to other adjustable solutions currently available
The lower section stays on the optic & is available in 25mm/30mm - 40mm (25/30mm is supplied with a bush to suit both sizes)
Available in 25/30mm 34mm 36mm & 40mm to allow you to fit most available scope sizes.
The lower section also fits out new NV screen system.
Pease select options above
25mm Torch body only
center to center between ring
The upper & lower parts are available individually if you need to use on multiple optics HERE
Please read carefully prior to fitment.....
Clip the bushing over your IR/Torch & fit into the adjustable mounting upper part.(the split in the bush should be on the side of the m4 cap head screw or damage may incur)
Tighten the m4 cap head fully being careful not to over tighten, you can then control the tension via the thumbwheel allowing you to rotate as desired.
When tightening the 4x cap heads to secure to your scope tube be sure to tighten evenly & be careful not to cross thread the fixings.
A single stretched wrap of electrical tape will help protect your scopes finish and aid grip,evenly tighten 4x cap head until secure and firm without over tightening.
Surface finish may vary depending on ABS/PETG type used .
Please note these are made in house so 0-5 working days depending on workload